#Laser rifle new vegas free#

#Laser rifle new vegas free#

Battery compartment :- It's made up from a baby formula bottle cut to fit in the gap and panel pinned and glued, the front circle is 3/4 mdf, the back circle is plastic 2 inch circle, screwed and glued, then bondo'd to form that cone to the back of the gun, Front vent and rear:- At the front I used 1/4 ply, pinned to the chamber and glued, then used whatever would make the recess on the inside sit right with me, I started to free wheel here to be honest, I like plans but at the same time I want to make my gun by me for me, so if I'm a little loose it's because I may not have measured and eye balled it or played it by ear to see what worked, after all this is my first weapon build so I was figuring it out as I went, I used the foam to cut out the vents on the front and back and just superglued them in, the placement was marked out, but the vents I made up to fit as I went.

Tools:- ( I'm not normally that messy in the pic, this was mid build! ) Saw Bandsaw Dremel tool Drills G clamps Sander ( orbital, belt, or just paper) Brushes ( small to 2 inch) Screwdrivers And again, anything I've forgot I'll explain on the way, but I think that's most stuff, I don't have a massive setup so I do with what I have, right on with the build! The tools and bits list is a big one, and chances are I'm probably gonna miss a bunch of stuff, because like the fallout helmet, I used what I could get my hands on and modified house hold items to try get the lazer look ! Materials:- Research pictures Off cuts of wood, mdf (3/4 inch) (1/4 inch) Off cut plastic Plastic tub Threaded rod, ( 6 mm rod, about 2ft) 2mm foam board Various paints, black, silver, olive drab, yellow, browns and clear coat spray paint Bits and bobs ( loose nuts, bottle nossel screws, masking tape, plumbing parts small, glue, wood glue or pva, superglue, and other bits, if I've forgot anything I'll explain on the way.